www.transmission24.de - WEBSHOP DB AUTOMOBILE GMBH
Ihr Spezialist für Getriebe- und Antriebstechnik
Auf Lager
62TE with Solenoid Pack | 62TE without Solenoid Pack |
---|---|
Part Noc VB-62TE-02 | Part No. VB-62TE-01 |
1. Before Installing onto Case
a. Remove and save the two bolts with nylon nuts. Remove U-shaped plate and rear
separator plate.
b. Install plastic screen/gasket onto solenoid pack and install assembly onto the aluminum
plate, aligning the dowels.
NOTE: The plastic screen/gasket will be damaged if cleaned with solvents or other harsh chemicals.
Clean it with dish liquid and water.
c. Place valve body on bench with the solenoid pack electric connector facing down.
d. Install checkballs in locations indicated in by the circles (Figure 1).
e. Install separator plate, separator plate gasket and U-shaped housing onto valve body
(Figure 2). Use a little assembly lube on the separator plate to hold the separator plate
gasket in place so it does not move and get damaged.
f. Install fourteen valve body bolts as indicated by the circles (Figure 2). Torque bolts to 50
in/lbs starting in the center and working around the outside in circular pattern.
g. Make sure accumulator springs and pistons are installed correctly and the 2-4 oil feed
tube is installed and seated onto case.
2. Case Installation
a. Install the valve body onto case aligning manual valve and the three tubes in the tube
assembly with the valve body (Figure 2). The dowels should drop into the holes on the case.
b. Install valve body to case bolts. Torque bolts to 50 in-lbs.
NOTE: Install flat detent spring with roller and make sure all internal wiring is routed correctly to
avoid pinched wires.
ÜBER TRANSMISSION24
|
KUNDENSERVICE
|
HILFE & SUPPORT
|
TOP AUTOMARKEN
|
TOP GETRIEBE
|
TOP PRODUKTE
|
Sicherheit |
|||||
|
|||||
|
|
||||
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|